Skin irritation, Category 2
H315 Causes skin irritation
P264 Wash ... thoroughly after handling.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/...
P302+P352 IF ON SKIN: Wash with plenty of water/...
P321 Specific treatment (see ... on this label).
P332+P317 If skin irritation occurs: Get medical help.
P362+P364 Take off contaminated clothing and wash it before reuse.
none
none
no data available
Fresh air, rest. Half-upright position. Refer for medical attention.
Remove contaminated clothes. Rinse and then wash skin with water and soap.
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.
Rinse mouth. Refer for medical attention .
no data available
no data available
Use dry chemical, carbon dioxide or alcohol-resistant foam.
Combustible. Finely dispersed particles form explosive mixtures in air.
Use water spray, foam, powder, dry sand. In case of fire: keep drums, etc., cool by spraying with water.
Personal protection: particulate filter respirator adapted to the airborne concentration of the substance. Sweep spilled substance into covered containers. If appropriate, moisten first to prevent dusting.
Prevent further spillage or leakage if it is safe to do so. Do not let the chemical enter drains. Discharge into the environment must be avoided.
Collect and arrange disposal. Keep the chemical in suitable and closed containers for disposal. Remove all sources of ignition. Use spark-proof tools and explosion-proof equipment. Adhered or collected material should be promptly disposed of, in accordance with appropriate laws and regulations.
NO open flames, NO sparks and NO smoking. Closed system, dust explosion-proof electrical equipment and lighting. Prevent deposition of dust. Prevent build-up of electrostatic charges (e.g., by grounding). Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.
Fireproof. Separated from strong oxidants.
Component | Sulfur | |||
---|---|---|---|---|
CAS No. | 7704-34-9 | |||
Limit value - Eight hours | Limit value - Short term | |||
ppm | mg/m3 | ppm | mg/m3 | |
Latvia | ? | 6 | ? | ? |
Remarks |
no data available
Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.
Wear safety goggles.
Protective gloves.
Use local exhaust or breathing protection.
no data available
Solid. Orthorhombic crystals or white granules.
no data available
no data available
114°C
444.7°C(lit.)
no data available
no data available
207°C
450°F
no data available
no data available
no data available
In water: 767 g/L. Temperature:25. pH:5 - 6.
log Pow = 0.48. Temperature:25 °C.
0 hPa. Temperature:25 °C.
1.77. Temperature:25 °C.
8.9 (vs air)
no data available
no data available
no data available
Dust explosion possible if in powder or granular form, mixed with air. If dry, it can be charged electrostatically by swirling, pneumatic transport, pouring, etc.On combustion, forms toxic and corrosive gases of sulfur oxides including sulfur dioxide (see ICSC 0074). Reacts violently with strong oxidants , especially if powdered. This generates fire and explosion hazard.
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
The substance is irritating to the eyes, skin and respiratory tract. Inhalation of the powder may cause inflammation of the nose and respiratory tract.
Repeated or prolonged contact with skin may cause dermatitis. The substance may have effects on the respiratory tract. This may result in chronic bronchitis.
Evaporation at 20°C is negligible; a harmful concentration of airborne particles can, however, be reached quickly when dispersed.
no data available
no data available
no data available
no data available
The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.
Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.
ADR/RID: UN1350 (For reference only, please check.)
IMDG: UN1350 (For reference only, please check.)
IATA: UN1350 (For reference only, please check.)
ADR/RID: SULPHUR (For reference only, please check.)
IMDG: SULPHUR (For reference only, please check.)
IATA: SULPHUR (For reference only, please check.)
ADR/RID: 4.1 (For reference only, please check.)
IMDG: 4.1 (For reference only, please check.)
IATA: 4.1 (For reference only, please check.)
ADR/RID: III (For reference only, please check.)
IMDG: III (For reference only, please check.)
IATA: III (For reference only, please check.)
ADR/RID: No
IMDG: No
IATA: No
no data available
no data available
Often transported in molten state (UN 2448; TEC(R)-115).Molten sulfur reacts with hydrocarbons to form toxic and flammable gases.Depending on the degree of exposure, periodic medical examination is indicated.