Substances and mixtures, which in contact with water, emit flammable gases, Category 1
Skin corrosion, Sub-category 1B
H260 In contact with water releases flammable gases which may ignite spontaneously
H314 Causes severe skin burns and eye damage
P223 Do not allow contact with water.
P231+P232 Handle and store contents under inert gas/....Protect from moisture.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/...
P260 Do not breathe dust/fume/gas/mist/vapours/spray.
P264 Wash ... thoroughly after handling.
P302+P335+P334 IF ON SKIN: Brush off loose particles from skin. Immerse in cool water [or wrap in wet bandages].
P370+P378 In case of fire: Use ... to extinguish.
P301+P330+P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P363 Wash contaminated clothing before reuse.
P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.
P316 Get emergency medical help immediately.
P321 Specific treatment (see ... on this label).
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P402+P404 Store in a dry place. Store in a closed container.
P405 Store locked up.
P501 Dispose of contents/container to an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.
no data available
Fresh air, rest. Half-upright position. No mouth-to-mouth artificial respiration. Refer immediately for medical attention.
Remove contaminated clothes. Put clothes in sealable container. Rinse skin with plenty of water or shower. Refer immediately for medical attention .
Rinse with plenty of water for several minutes (remove contact lenses if easily possible). Refer immediately for medical attention.
Rinse mouth. Do NOT induce vomiting. Refer immediately for medical attention.
This material is relatively toxic to people. It is more likely to cause irritation of skin and mucous membrane tissues rather than death. Its effects are primarily acute. A massive exposure to the eyes and by inhalation may be lethal. Those experiencing any ailment of the upper respiratory tract (e.g., bronchitis or pneumonia) are at a greater risk. (EPA, 1998)
Basic treatment: Establish a patent airway (oropharyngeal or nasopharyngeal airway, if needed). Suction if necessary. Watch for signs of respiratory insufficiency and assist ventilations if necessary. Administer oxygen by nonrebreather mask at 10 to 15 L/min. Monitor for pulmonary edema and treat if necessary ... Monitor for shock and treat if necessary ... Anticipate seizures and treat if necessary ... For eye contamination, flush eyes immediately with water. Irrigate each eye continuously with 0.9% saline (NS) during treatment ... Do not use emetics. For ingestion, rinse mouth and administer 5 ml/kg up to 200 ml of water for dilution if the patient can swallow, has a strong gag reflex, and does not drool ... Cover skin burns with dry sterile dressings after decontamination ... Lithium and related compounds
Use approved Class D extinguishers or smother with dry sand, dry clay, or dry ground limestone. Do not use carbon dioxide or halogenated extinguishing agents. Do NOT use water. Violent reaction may result.
In a fire, irritating alkali fumes may form. Lithium hydride can form airborne dust clouds which may explode on contact with flame, heat, or oxidizing materials. Additionally, spontaneous ignition occurs when nitrous oxide and lithium hydride are mixed. Lithium hydride also forms explosive mixtures with liquid oxygen. Contact with heat, moisture or acid causes exothermic reaction and evolution of hydrogen as well as lithium hydroxide. Incompatible with air and moisture, nitrous oxide, strong oxidizers, and liquid oxygen. Lithium hydride may ignite spontaneously in air and should be maintained and handled out of contact with air and moisture. Any contact with nitrous oxide; airborne powders may ignite upon reaching moisture. (EPA, 1998)
Wear self-contained breathing apparatus for firefighting if necessary.
Avoid dust formation. Avoid breathing mist, gas or vapours.Avoid contacting with skin and eye. Use personal protective equipment.Wear chemical impermeable gloves. Ensure adequate ventilation.Remove all sources of ignition. Evacuate personnel to safe areas.Keep people away from and upwind of spill/leak.
Evacuate danger area! Consult an expert! Personal protection: chemical protection suit including self-contained breathing apparatus. Cover the spilled material with dry powder.
Wearing butyl rubber gloves, fireproof clothing, face shield and goggles, cover spill with sand. Transfer mixture into a dry plastic bag filled in advance with an inert gas. Carry outdoors for incineration. After burning (if not in a proper incinerator), sprinkle water on the residue for complete destruction. Alternatively, in the fume hood, add butanol slowly to the solid mixture until the reaction ceases. Then carefully add water until all the hydride is destroyed. Let stand until solid settles.
Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.
Separated from incompatible materials. See Chemical Dangers. Dry. Keep under mineral oil or inert gas. Cool. Store in an area without drain or sewer access.Store in a cool, dry, well-ventilated location. Must be stored in a dry location. Immediately remove and properly dispose of any spilled material.
Component | Lithium (2H)hydride |
---|---|
CAS No. | 13587-16-1 |
Recommended Exposure Limit: 10 Hr Time-Weighted Avg: 0.025 mg/cu m. |
no data available
Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.
Wear tightly fitting safety goggles with side-shields conforming to EN 166(EU) or NIOSH (US).
Wear fire/flame resistant and impervious clothing. Handle with gloves. Gloves must be inspected prior to use. Wash and dry hands. The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and the standard EN 374 derived from it.
If the exposure limits are exceeded, irritation or other symptoms are experienced, use a full-face respirator.
no data available
Lithium hydride is a white or translucent crystalline mass or powder. The commercial product is light bluish-gray lumps due to the presence of minute amounts of colloidally dispersed lithium.
Gray cubic crystals or powder, hygroscopic
Odorless ...
680°C
Decomposes (NIOSH, 2016)
Combustible Solid that can form airborne dust clouds which may explode on contact with flame, heat, or oxidizers.
no data available
no data available
392° F (USCG, 1999)
850°C
no data available
no data available
Reacts with water (NIOSH, 2016)
no data available
0 mm Hg at 68° F (EPA, 1998)
0.82
no data available
no data available
Decomposes on contact with hot surfaces or flames. This produces irritating alkali fumes. The substance may ignite spontaneously on contact with moist air. The substance is a strong reducing agent. Reacts violently with oxidants, halogenated hydrocarbons and acids. This produces flammable/explosive gas (hydrogen - see ICSC 0001). Reacts violently with water. This produces corrosive fumes of lithium hydroxide.
Darkens rapidly on exposure to light.
Lithium hydride is a flammable solid and is dangerous when wet.Dust explosion possible if in powder or granular form, mixed with air.LITHIUM HYDRIDE is a strong reducing agent. Th esolid may decompose violently in contact with most oxidizing materials. It reacts exothermically with water to form caustic lithium hydroxide and hydrogen gas; the hydrogen may ignite. May ignite spontaneously in moist air. Mixtures with liquid oxygen are explosive. Ignites on contact with dinitrogen oxide [Mellor, 1967, vol. 8, suppl. 2.2, p. 214].
no data available
Reacts with the lower alcohols, carboxylic acids, chlorine and ammonia at 400 deg C to liberate hydrogen.
Thermally unstable. Decomp at 1009 deg F (400 deg C).
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.
Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.
ADR/RID: UN1414 (For reference only, please check.)
IMDG: UN1414 (For reference only, please check.)
IATA: UN1414 (For reference only, please check.)
ADR/RID: LITHIUM HYDRIDE (For reference only, please check.)
IMDG: LITHIUM HYDRIDE (For reference only, please check.)
IATA: LITHIUM HYDRIDE (For reference only, please check.)
ADR/RID: 4.3 (For reference only, please check.)
IMDG: 4.3 (For reference only, please check.)
IATA: 4.3 (For reference only, please check.)
ADR/RID: I (For reference only, please check.)
IMDG: I (For reference only, please check.)
IATA: I (For reference only, please check.)
ADR/RID: No
IMDG: No
IATA: No
no data available
no data available