Acute toxicity - Category 3, Oral
Acute toxicity - Category 3, Dermal
Skin corrosion, Sub-category 1B
Acute toxicity - Category 3, Inhalation
Hazardous to the aquatic environment, short-term (Acute) - Category Acute 1
H301+H311+H331 Toxic if swallowed, in contact with skin or if inhaled
H314 Causes severe skin burns and eye damage
H400 Very toxic to aquatic life
P264 Wash ... thoroughly after handling.
P270 Do not eat, drink or smoke when using this product.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/...
P260 Do not breathe dust/fume/gas/mist/vapours/spray.
P261 Avoid breathing dust/fume/gas/mist/vapours/spray.
P271 Use only outdoors or in a well-ventilated area.
P273 Avoid release to the environment.
P301+P316 IF SWALLOWED: Get emergency medical help immediately.
P321 Specific treatment (see ... on this label).
P330 Rinse mouth.
P302+P352 IF ON SKIN: Wash with plenty of water/...
P316 Get emergency medical help immediately.
P361+P364 Take off immediately all contaminated clothing and wash it before reuse.
P301+P330+P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P363 Wash contaminated clothing before reuse.
P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P391 Collect spillage.
P405 Store locked up.
P403+P233 Store in a well-ventilated place. Keep container tightly closed.
P501 Dispose of contents/container to an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.
no data available
Fresh air, rest. Half-upright position. Artificial respiration may be needed. Refer for medical attention.
Remove contaminated clothes. Rinse skin with plenty of water or shower. Refer for medical attention .
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.
Rinse mouth. Do NOT induce vomiting. Give one or two glasses of water to drink. Rest. Refer for medical attention .
Excerpt from ERG Guide 131 [Flammable Liquids - Toxic]: TOXIC; may be fatal if inhaled, ingested or absorbed through skin. Inhalation or contact with some of these materials will irritate or burn skin and eyes. Fire will produce irritating, corrosive and/or toxic gases. Vapors may cause dizziness or suffocation. Runoff from fire control or dilution water may cause pollution. (ERG, 2016)
no data available
Use dry chemical, carbon dioxide, foam, or water spray. water may be ineffective. use water spray to keep fire-exposed containers cool. approach fire from upwind to avoid hazardous vapors & toxic decomposition products.
Excerpt from ERG Guide 131 [Flammable Liquids - Toxic]: HIGHLY FLAMMABLE: Will be easily ignited by heat, sparks or flames. Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks). Vapor explosion and poison hazard indoors, outdoors or in sewers. Those substances designated with a (P) may polymerize explosively when heated or involved in a fire. Runoff to sewer may create fire or explosion hazard. Containers may explode when heated. Many liquids are lighter than water. (ERG, 2016)
Use water spray, powder, alcohol-resistant foam, carbon dioxide. In case of fire: keep drums, etc., cool by spraying with water.
Personal protection: chemical protection suit including self-contained breathing apparatus. Remove all ignition sources. Collect leaking and spilled liquid in sealable containers as far as possible. Absorb remaining liquid in sand or inert absorbent. Then store and dispose of according to local regulations.
Personal protection: chemical protection suit including self-contained breathing apparatus. Remove all ignition sources. Collect leaking and spilled liquid in sealable containers as far as possible. Absorb remaining liquid in sand or inert absorbent. Then store and dispose of according to local regulations.
Collect and arrange disposal. Keep the chemical in suitable and closed containers for disposal. Remove all sources of ignition. Use spark-proof tools and explosion-proof equipment. Adhered or collected material should be promptly disposed of, in accordance with appropriate laws and regulations.
NO open flames, NO sparks and NO smoking. Above 51°C use a closed system, ventilation and explosion-proof electrical equipment. Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.
Fireproof. Separated from food and feedstuffs. See Chemical Dangers. Cool. Dry. Well closed. Keep in a well-ventilated room.Store in a cool, dry, well ventilated location. Separate from acids and oxidizing materials.
no data available
no data available
Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.
Wear face shield.
Protective gloves. Protective clothing.
Use ventilation, local exhaust or breathing protection.
no data available
Di-n-amylamine is a clear colorless liquid with an ammonia-like odor. Very slightly soluble in water. Less dense less than water. Vapors heavier than air. Difficult to ignite. Moderately toxic. Contact with liquid may cause a chemical burn. Vapors may irritate respiratory tract. Used in the manufacture of rubber, resins, and dyes.
COLORLESS TO WATER-WHITE TO PALE-YELLOW LIQUID
CHARACTERISTIC AMINE ODOR
215°C(lit.)
127°C/18mmHg
Flammable. Gives off irritating or toxic fumes (or gases) in a fire.
FLAMMABLE LIMITS NOT RECORDED.
51°C(lit.)
no data available
no data available
no data available
no data available
Slightly soluble (1-10 mg/ml) (NTP, 1992)
no data available
0.3 mm Hg ( 20 °C)
0.777
5.42 (vs air)
no data available
Decomposes on burning. This produces toxic and corrosive gases including nitrogen oxides. Reacts violently with oxidants, acids, acid chlorides, acid anhydrides and mercury. Attacks plastics, copper, copper alloys, aluminium, zinc, zinc alloys and galvanized surfaces. Solutions in water may attack glass.
no data available
Flammable liquid when exposed to heat or flame ...DI-N-AMYLAMINE neutralizes acids to form salts plus water. May be incompatible with isocyanates, halogenated organics, peroxides, phenols (acidic), epoxides, anhydrides, and acid halides. Flammable gaseous hydrogen is generated in combination with strong reducing agents, such as hydrides.
no data available
Can react with oxidizing materials.
When heated to decomp it emits toxic fumes of /nitrogen oxides/.
no data available
no data available
no data available
no data available
no data available
no data available
The substance is corrosive to the skin and eyes. The substance is severely irritating to the respiratory tract. Inhalation of the vapour or mist may cause lung oedema. See Notes. The substance may cause effects on the central nervous system.
no data available
No indication can be given about the rate at which a harmful concentration of this substance in the air is reached on evaporation at 20°C.
No data was found regarding the biodegradation of dipentylamine; however, screening studies on other aliphatic amines(1-6) suggest that dipentylamine may biodegrade in the environment(SRC).
An estimated BCF of 156 was calculated for dipentylamine(SRC), using an estimated log Kow of 3.76(1) and a regression-derived equation(2). According to a classification scheme(3), this BCF suggests the potential for bioconcentration in aquatic organisms is high(SRC).
The Koc of dipentylamine was estimated as 1,800(SRC), using an estimated log Kow of 3.76(1) and a regression-derived equation(2). According to a classification scheme(3), this estimated Koc value suggests that dipentylamine is expected to have low mobility in soil(SRC). The pKa of dipentylamine is 11.16(4), indicating that the protonated form will be the predominant species in moist soils and cations are expected to adsorb strongly to soil surfaces.
no data available
The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.
Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.
ADR/RID: UN2841 (For reference only, please check.)
IMDG: UN2841 (For reference only, please check.)
IATA: UN2841 (For reference only, please check.)
ADR/RID: DI-n-AMYLAMINE (For reference only, please check.)
IMDG: DI-n-AMYLAMINE (For reference only, please check.)
IATA: DI-n-AMYLAMINE (For reference only, please check.)
ADR/RID: 3 (For reference only, please check.)
IMDG: 3 (For reference only, please check.)
IATA: 3 (For reference only, please check.)
ADR/RID: III (For reference only, please check.)
IMDG: III (For reference only, please check.)
IATA: III (For reference only, please check.)
ADR/RID: Yes
IMDG: Yes
IATA: Yes
no data available
no data available
Other melting points: -8°C; -32°C.Explosive limits are unknown in literature, although the substance is combustible and has a flash point < 55°C.The symptoms of lung oedema often do not become manifest until a few hours have passed and they are aggravated by physical effort.Rest and medical observation is therefore essential.Insufficient data are available on the effect of this substance on human health, therefore utmost care must be taken.