Gases under pressure: Compressed gas
Skin corrosion, Sub-category 1A
Acute toxicity - Category 2, Inhalation
H314 Causes severe skin burns and eye damage
H330 Fatal if inhaled
P260 Do not breathe dust/fume/gas/mist/vapours/spray.
P264 Wash ... thoroughly after handling.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/...
P271 Use only outdoors or in a well-ventilated area.
P284 [In case of inadequate ventilation] wear respiratory protection.
P301+P330+P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P363 Wash contaminated clothing before reuse.
P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.
P316 Get emergency medical help immediately.
P321 Specific treatment (see ... on this label).
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P320 Specific treatment is urgent (see ... on this label).
P410+P403 Protect from sunlight. Store in a well-ventilated place.
P405 Store locked up.
P403+P233 Store in a well-ventilated place. Keep container tightly closed.
P501 Dispose of contents/container to an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.
no data available
Fresh air, rest. Half-upright position. Artificial respiration may be needed. Refer for medical attention.
First rinse with plenty of water for at least 15 minutes, then remove contaminated clothes and rinse again. Refer for medical attention .
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.
Rinse mouth with water. Do not induce vomiting. Never give anything by mouth to an unconscious person. Call a doctor or Poison Control Center immediately.
Highly toxic; may cause death or permanent injury after very short exposure to small quantities. Substance is irritating to the eyes, the skin, and the respiratory tract. (EPA, 1998)
If strong concentrations of boron trifluoride gas get into the eyes, wash eyes immediately with large amounts of water, lifting the lower and upper lids occasionally. Get medical attention immediately. Contact lenses should not be worn when working with this chemical.
Approach fire from upwind to avoid hazardous vapors and toxic decomposition products. Use water spray to keep fire-exposed containers cool. Extinguish fire using agent suitable for surrounding fire.
When heated to decomposition or upon contact with water or steam, it will produce toxic and corrosive fumes of fluorine containing compounds. Decomposes upon heating or on contact with moist air, forming toxic and corrosive fumes of boric acid and hydrofluoric acid. Reacts with alkalis and fumes in moist air, producing particulates which reduce visibility. Reacts with alkali metals, alkaline earth metals (except magnesium), alkyl nitrates, and calcium oxide. It hydrolyzes in moist air to form boric acid, hydrofluoric acid, and fluoboric acid. (EPA, 1998)
In case of fire in the surroundings: use appropriate extinguishing media. In case of fire: keep cylinder cool by spraying with water. NO direct contact with water.
Evacuate danger area! Consult an expert! Personal protection: complete protective clothing including self-contained breathing apparatus. Ventilation. NEVER direct water jet on liquid. Remove fumes with fine water spray.
Evacuate danger area! Consult an expert! Personal protection: complete protective clothing including self-contained breathing apparatus. Ventilation. NEVER direct water jet on liquid. Remove fumes with fine water spray.
Approach release from upwind. Stop or control the leak, if this can be done without undue risk. Use water spray to cool and disperse vapors and protect personnel. Avoid wetting leak or spill area. Releases may require isolation or evacuation.
Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.
Separated from alkali metals, alkaline earth metals, alkyl nitrates and lime. Cool.Store in cool, dry, well-ventilated location. Outside or detached storage is preferred. Separate from water, active metals, monomers.
Component | Boron trifluoride | |||
---|---|---|---|---|
CAS No. | 7637-07-2 | |||
Limit value - Eight hours | Limit value - Short term | |||
ppm | mg/m3 | ppm | mg/m3 | |
Australia | ? | ? | 1 (1) | 2,8 (1) |
Austria | 1 | 3 | 1 | 3 |
Belgium | ? | ? | 1 | 3 |
Canada - Ontario | ? | ? | 1 (1) | ? |
Canada - Québec | ? | ? | 1 (1) | 2,8 (1) |
Denmark | 1 | 3 | 1 | 3 |
Finland | 1 | 2,8 | 3 (1) | 8,4 (1) |
France | ? | ? | 1 | 3 |
Germany (AGS) | 0,35 | 1 | 0,7 (1) | 2 (1) |
Ireland | ? | ? | 1 (1) | 3 (1) |
Japan - JSOH | 0,3 | 0,83 | ? | ? |
Latvia | ? | 1 | ? | ? |
New Zealand | ? | ? | 1 (1) | 2,8 (1) |
People's Republic of China | ? | ? | ? | 3 (1) |
Poland | ? | ? | ? | 3 (1) |
Singapore | ? | ? | 1 | 2,8 |
South Korea | ? | ? | 1 (1) | 3 (1) |
Spain | ? | ? | 1 | 3 |
Switzerland | 1 | 3 | 1 | 3 |
USA - NIOSH | ? | ? | 1 (1) | 3 (1) |
USA - OSHA | ? | ? | 1 | 3 |
United Kingdom | ? | ? | [1] | [2,8] |
Remarks | ||||
Australia | (1) Ceiling limit value | |||
Canada - Ontario | (1) Ceiling limit value | |||
Canada - Québec | (1) Ceiling limit value | |||
Finland | (1) 15 minutes average value | |||
Germany (AGS) | (1) 15 minutes average value | |||
Ireland | (1) 15 minutes reference period | |||
New Zealand | (1) Ceiling limit value | |||
People's Republic of China | (1) Ceiling limit value | |||
Poland | (1) Ceiling limit value | |||
South Korea | (1) Ceiling limit value | |||
USA - NIOSH | (1) Ceiling limit value | |||
United Kingdom | The UK Advisory Committee on Toxic Substances has expressed concern that, for the OELs shown in parentheses, health may not be adequately protected because of doubts that the limit was not soundly-based. These OELs were included in the published UK 2002 list and its 2003 supplement, but are omitted from the published 2005 list. |
no data available
Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.
Wear face shield or eye protection in combination with breathing protection.
Protective gloves. Cold-insulating gloves. Protective clothing.
Use ventilation, local exhaust or breathing protection.
no data available
Boron trifluoride is a colorless gas with a pungent odor. It is toxic by inhalation. It is soluble in water and slowly hydrolyzed by cold water to give off hydrofluoric acid, a corrosive material. Its vapors are heavier than air. Prolonged exposure of the containers to fire or heat may result in their violent rupturing and rocketing.
Colorless gas
Pungent, suffocating odor
-20°C
?100°C(lit.)
Nonflammable Gas
no data available
4°C
no data available
no data available
no data available
0.0171 m Pa.s (gas) at 25 deg C
106 % (in cold H2O) (NIOSH, 2016)
no data available
760 mm Hg at -149.26° F Liquid (EPA, 1998)
0.87
2.38 (21 °C, vs air)
no data available
The substance polymerizes unsaturated compounds. Decomposes on contact with water or moisture. This produces toxic and corrosive fumes including hydrogen fluoride (see ICSC 0283), fluoroboric acid and boric acid. Reacts violently with metals such as sodium, potassium and calcium and alkyl nitrates alkyl nitrates. Attacks many metals in the presence of water.
Boron trifluoride ... is stable in dry atmospheres.
Nonflammable compressed gas.The gas is heavier than air.BORON TRIFLUORIDE is a colorless, strongly irritating, toxic gas. Upon contact with water, steam or when heated to decomposition, it will produce toxic fluoride fumes. Incompatible with alkyl nitrates, calcium oxide. Reaction with alkali metals or alkaline earth metals (except magnesium) will cause incandescence [Bretherick, 5th ed., 1995, p. 65].
no data available
Boron trifluoride reacts with incandescence when heated with alkali metals or alkaline earth metals, except magnesium.
Dangerous; when heated to decomposition or upon contact with water or steam, will produce toxic and corrosive fumes of /hydrogen fluoride/.
no data available
no data available
no data available
no data available
no data available
no data available
The substance is corrosive to the eyes, skin and respiratory tract. Inhalation of high concentrations may cause lung oedema, but only after initial corrosive effects on the eyes and the upper respiratory tract have become manifest. See Notes. Rapid evaporation of the liquid may cause frostbite.
The substance may have effects on the kidney, lungs and teeth and bones (fluorosis).
A harmful concentration of this gas in the air will be reached very quickly on loss of containment.
no data available
no data available
no data available
no data available
The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.
Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.
ADR/RID: UN1008 (For reference only, please check.)
IMDG: UN1008 (For reference only, please check.)
IATA: UN1008 (For reference only, please check.)
ADR/RID: BORON TRIFLUORIDE (For reference only, please check.)
IMDG: BORON TRIFLUORIDE (For reference only, please check.)
IATA: BORON TRIFLUORIDE (For reference only, please check.)
ADR/RID: 2.3 (For reference only, please check.)
IMDG: 2.3 (For reference only, please check.)
IATA: 2.3 (For reference only, please check.)
ADR/RID: (For reference only, please check.)
IMDG: (For reference only, please check.)
IATA: (For reference only, please check.)
ADR/RID: No
IMDG: No
IATA: No
no data available
no data available
Boron trifluoride is soluble in cold water, 332 g/100 ml at 0°C.The occupational exposure limit value should not be exceeded during any part of the working exposure.Depending on the degree of exposure, periodic medical examination is suggested.The symptoms of lung oedema often do not become manifest until a few hours have passed and they are aggravated by physical effort. Rest and medical observation are therefore essential.Immediate administration of an appropriate inhalation therapy by a doctor or a person authorized by him/her, should be considered.