Acute toxicity - Category 3, Oral
Acute toxicity - Category 3, Dermal
Skin corrosion, Sub-category 1B
H301 Toxic if swallowed
H311 Toxic in contact with skin
H314 Causes severe skin burns and eye damage
P264 Wash ... thoroughly after handling.
P270 Do not eat, drink or smoke when using this product.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/...
P260 Do not breathe dust/fume/gas/mist/vapours/spray.
P301+P316 IF SWALLOWED: Get emergency medical help immediately.
P321 Specific treatment (see ... on this label).
P330 Rinse mouth.
P302+P352 IF ON SKIN: Wash with plenty of water/...
P316 Get emergency medical help immediately.
P361+P364 Take off immediately all contaminated clothing and wash it before reuse.
P301+P330+P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P363 Wash contaminated clothing before reuse.
P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P405 Store locked up.
P501 Dispose of contents/container to an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.
no data available
Fresh air, rest. Half-upright position. Artificial respiration may be needed. Refer for medical attention.
Wear protective gloves when administering first aid. Rinse and then wash skin with water and soap. Refer for medical attention .
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.
Rest. Do NOT induce vomiting. Refer for medical attention .
SYMPTOMS: Symptoms of exposure to this compound may include corrosion of the mucous membranes, upper respiratory tract, skin, and eyes; burning sensation, coughing, wheezing, laryngitis, and shortness of breath. Other symptoms may include severe irritation or burning of the eyes and skin; irritation of the respiratory system; dizziness, stomach pain, exhaustion, and coma. It can cause headaches, nausea, and vomiting. It can also cause dermatitis, muscular weakness, dimness of vision, irregular and rapid breathing, ringing in the ears, weak pulse, dyspnea, and unconsciousness. It can damage the kidneys, liver, pancreas, and spleen; and cause edema of the lungs. Inhalation may be fatal as a result of spasm, inflammation, and edema of the larynx and bronchi; chemical pneumonitis; and pulmonary edema. Chronic exposure can lead to digestive disturbances, nervous disorders, and skin eruptions. ACUTE/CHRONIC HAZARDS: This compound is highly toxic by inhalation, ingestion or skin absorption. It is corrosive and extremely destructive to tissue of the mucous membranes, upper respiratory tract, eyes and skin. When heated to decomposition it emits acrid smoke and toxic fumes of carbon monoxide and carbon dioxide. (NTP, 1992)
Basic treatment: Establish a patent airway. Suction if necessary. Watch for signs of respiratory insufficiency and assist ventilations if necessary. Administer oxygen by nonrebreather mask at 10 to 15 L/min. Monitor for pulmonary edema and treat if necessary . Monitor for shock and treat if necessary . Anticipate seizures and treat if necessary . For eye contamination, flush eyes immediately with water. Irrigate each eye continuously with normal saline during transport . Administer activated charcoal . Dilution may be contraindicated because it may increase absorption. Do not use emetics . Cover skin burns with dry sterile dressings after decontamination . Phenols and Related compounds
Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)
Flash point data for this chemical are not available. It is probably combustible. (NTP, 1992)
Use water spray, powder, alcohol-resistant foam, carbon dioxide.
Personal protection: chemical protection suit including self-contained breathing apparatus. Sweep spilled substance into covered sealable containers. Do NOT let this chemical enter the environment.
Sweep spilled substance into covered sealable containers. Do NOT let this chemical enter the environment. Personal protection: chemical protection suit including self-contained breathing apparatus.
Collect and arrange disposal. Keep the chemical in suitable and closed containers for disposal. Remove all sources of ignition. Use spark-proof tools and explosion-proof equipment. Adhered or collected material should be promptly disposed of, in accordance with appropriate laws and regulations.
NO open flames. Closed system, dust explosion-proof electrical equipment and lighting. Prevent deposition of dust. Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.
Separated from acid anhydrides, acid chlorides, bases and oxidants.
no data available
no data available
Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.
Wear safety goggles, face shield or eye protection in combination with breathing protection.
Protective gloves. Protective clothing.
Use local exhaust or breathing protection.
no data available
Solid. Crystalline.
White to slight yellow.
no data available
62.1 °C. Atm. press.:1 013 hPa. Remarks:-.
221 °C. Atm. press.:987 mBar. Remarks:-.
Combustible.
no data available
101 °C. Atm. press.:1 013 hPa.
> 555 °C. Atm. press.:1 013 mBar.
no data available
no data available
dynamic viscosity (in mPa s) = 2.4. Temperature:90.0°C.
less than 1 mg/mL at 68° F (NTP, 1992)
log Pow = 2.35. Temperature:25.5 °C. Remarks:-.
5 Pa. Temperature:25 °C. Remarks:-.
0.967 g/cm3. Temperature:75 °C.
(air = 1): 4.2
no data available
Reacts with acid anhydrides, acid chlorides, bases and oxidants.
no data available
Dust explosion possible if in powder or granular form, mixed with air.3,5-DIMETHYLPHENOL is incompatible with bases, acid chlorides, acid anhydrides, and oxidizing agents. It corrodes steel, brass, copper, and copper alloys. (NTP, 1992)
no data available
no data available
When heated to decomp it emits acrid smoke and irritating fumes.
no data available
no data available
no data available
no data available
no data available
no data available
The substance is corrosive to the eyes and skin. The substance is irritating to the respiratory tract. Corrosive on ingestion. See Notes.
See Notes.
No indication can be given about the rate at which a harmful concentration of this substance in the air is reached on evaporation at 20°C.
Anaerobic degradation of phenolic compounds to methane and carbon dioxide in sewage sludge digestion occurred in both ground water and laboratory digestors. water samples were collected from the near surface ground water in an area contaminated with plant process wastes resulting from operation of a coal tar distilling and wood treating plant. phenolic compounds (including 3,5-dimethylphenol) were isolated from the aqueous samples by dichloromethane extraction.
An estimated BCF of 36 was calculated for 3,5-dimethylphenol(SRC), using a log Kow of 2.35(1) and a regression-derived equation(2). According to a classification scheme(3), this BCF suggests the potential for bioconcentration in aquatic organisms is moderate.
The Koc of 3,5-dimethylphenol in soils with an organic carbon content <0.15% ranged from 460-1400; the Koc for 3,5-dimethylphenol in Dormont soil (organic carbon content = 1.5%) was determined to be 190(1). According to a classification scheme(2), these Koc values suggest that 3,5-dimethylphenol is expected to have moderate to low mobility in soil(SRC).
no data available
The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.
Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.
ADR/RID: UN2261 (For reference only, please check.)
IMDG: UN2261 (For reference only, please check.)
IATA: UN2261 (For reference only, please check.)
ADR/RID: XYLENOLS, SOLID (For reference only, please check.)
IMDG: XYLENOLS, SOLID (For reference only, please check.)
IATA: XYLENOLS, SOLID (For reference only, please check.)
ADR/RID: 6.1 (For reference only, please check.)
IMDG: 6.1 (For reference only, please check.)
IATA: 6.1 (For reference only, please check.)
ADR/RID: II (For reference only, please check.)
IMDG: II (For reference only, please check.)
IATA: II (For reference only, please check.)
ADR/RID: No
IMDG: No
IATA: No
no data available
no data available
See ICSCs 0070 and 601.Insufficient data are available on the effect of this substance on human health, therefore utmost care must be taken.Health effects may be similar to those of phenol and related compounds.