Acute toxicity - Category 4, Oral
Acute toxicity - Category 4, Dermal
Acute toxicity - Category 4, Inhalation
Hazardous to the aquatic environment, long-term (Chronic) - Category Chronic 2
H302 Harmful if swallowed
H312 Harmful in contact with skin
H332 Harmful if inhaled
H411 Toxic to aquatic life with long lasting effects
P264 Wash ... thoroughly after handling.
P270 Do not eat, drink or smoke when using this product.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/...
P261 Avoid breathing dust/fume/gas/mist/vapours/spray.
P271 Use only outdoors or in a well-ventilated area.
P273 Avoid release to the environment.
P301+P317 IF SWALLOWED: Get medical help.
P330 Rinse mouth.
P302+P352 IF ON SKIN: Wash with plenty of water/...
P317 Get medical help.
P321 Specific treatment (see ... on this label).
P362+P364 Take off contaminated clothing and wash it before reuse.
P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.
P391 Collect spillage.
none
P501 Dispose of contents/container to an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.
no data available
Fresh air, rest. Refer for medical attention.
Remove contaminated clothes. Rinse and then wash skin with water and soap. Refer for medical attention .
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.
Rinse mouth. Induce vomiting (ONLY IN CONSCIOUS PERSONS!). Refer for medical attention .
SYMPTOMS: Symptoms of exposure to this compound include irritation, burns and corrosion of the eyes, skin, mucous membranes and upper respiratory tract. It may also cause restlessness, increase in rate of respiration, motor weakness, tremors, clonic convulsions, dyspnea, coma and death. ACUTE/CHRONIC HAZARDS: This compound is toxic by inhalation, ingestion and skin absorption. When heated to decomposition it emits toxic fumes of carbon monoxide, carbon dioxide and hydrogen chloride gas. This compound may be corrosive. (NTP, 1992)
Immediate first aid: Ensure that adequate decontamination has been carried out. If patient is not breathing, start artificial respiration, preferably with a demand-valve resuscitator, bag-valve-mask device, or pocket mask, as trained. Perform CPR as necessary. Immediately flush contaminated eyes with gently flowing water. Do not induce vomiting. If vomiting occurs, lean patient forward or place on left side (head-down position, if possible) to maintain an open airway and prevent aspiration. Keep patient quiet and maintain normal body temperature. Obtain medical attention. Phenols and related compounds
Use dry chemical, carbon dioxide, or foam extinguishers. Vapors are heavier than air and well collect in low areas. ...Vapors in confined areas may explode when exposed to fire. Containers may explode in fire. Storage containers and parts of containers may rocket great distances, in many directions. ...From a secure, explosion-proof location, use water spray to cool exposed containers. If cooling streams are ineffective (venting sound increases in volume and pitch, tank discolors, or shows any signs of deforming), withdraw immediately to a secure position. Monochlorophenols
This chemical is probably combustible. (NTP, 1992)
Use water spray, foam, powder, carbon dioxide.
Personal protection: particulate filter respirator adapted to the airborne concentration of the substance. Do NOT let this chemical enter the environment. Sweep spilled substance into covered containers. If appropriate, moisten first to prevent dusting. Carefully collect remainder. Then store and dispose of according to local regulations.
Personal protection: particulate filter respirator adapted to the airborne concentration of the substance. Do NOT let this chemical enter the environment. Sweep spilled substance into covered containers. If appropriate, moisten first to prevent dusting. Carefully collect remainder. Then store and dispose of according to local regulations.
Phenolic cmpd in wastewater are oxidized with hydrogen peroxide catalyzed by iron(3+)-iron(2+). When the wt ratio of phenol:hydrogen peroxide is 1:3 and iron 5-100 ppm, more than 95% of the phenols are removed in 30 min from a 500 ppm phenol soln at pH 5-6 and 25-50 deg C. Phenolic cmpd
NO open flames. Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.
Separated from strong oxidants and food and feedstuffs. Well closed.Store in tightly closed containers in a cool, well ventilated area. Metal containers involving the transfer of this chemical should be grounded and bonded. Where possible, automatically pump liquid from drums or other storage containers to precess containers. Drums must be equipped with self-closing valves, pressure vacuum bungs, and flame arresters. Use only non-sparking tools and equipment, especially when opening and closing containers of this chemical. Sources of ignition such as smoking and open flames, are prohibited where this chemical is used, handled, or stored in a manner that could create a potential fire or explosion hazard. Monochlorophenols
Component | 3-chlorophenol | |||
---|---|---|---|---|
CAS No. | 108-43-0 | |||
Limit value - Eight hours | Limit value - Short term | |||
ppm | mg/m3 | ppm | mg/m3 | |
Denmark | ? | 0,5 | ? | 1,0 |
Remarks |
no data available
Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.
Wear safety goggles.
Protective gloves. Protective clothing.
Use local exhaust.
no data available
PHYSICAL DESCRIPTION: White crystals with an odor of phenol. Sinks in and slowly dissolves in water. (NTP, 1992)
Needles
Odor similar to phenol
-33°C(lit.)
159°C
Combustible. Gives off irritating or toxic fumes (or gases) in a fire.
no data available
30°C(lit.)
no data available
no data available
no data available
11.55 cP at 25 deg C
10 to 50 mg/mL at 59° F (NTP, 1992)
2.47/2.52
0.109mmHg at 25°C
1.218
no data available
no data available
Decomposes on heating. This produces toxic and corrosive fumes of hydrogen chloride (see ICSC 0163) and chlorine (see ICSC 0126). Reacts with oxidants.
Discolors on exposure to air.
M-CHLOROPHENOL is incompatible with acid chlorides, acid anhydrides and oxidizing agents (NTP, 1992).
no data available
no data available
When heated to decomposition it emits toxic fumes of /hydrogen chloride/.
no data available
no data available
no data available
no data available
no data available
no data available
The substance is irritating to the eyes, skin and respiratory tract.
no data available
No indication can be given about the rate at which a harmful concentration of this substance in the air is reached on evaporation at 20°C.
AEROBIC: Biological degradation of chlorophenols in activated sludge ... 3-chlorophenol was found at a level of 100 mg/L, and was completetly degraded in three days with 100% ring degradation.
Carp exposed to 40 ug/L of 3-chlorophenol for a period of 6 weeks had BCF values in the range of 5.1-10 and carp exposed to 4 ug/L of 3-chlorophenol for a period of 6 weeks had BCF values in the range of 7.0-16(1). A BCF value of 20.0 (logBCF = 1.30) for 3-chlorophenol was reported(2). According to a classification scheme(3), these BCF values suggest that the potential for bioconcentration in aquatic organisms is low(SRC).
The Koc of 3-chlorophenol in soil was reported as 350(1). According to a classification scheme(2), this Koc value suggests that 3-chlorophenol is expected to have moderate mobility in soil(SRC). The pKa of 3-chlorophenol is 9.12(3), indicating that this compound will partially exist in the anion form in the environment and anions generally do not adsorb more strongly to soils containing organic carbon and clay than their neutral counterparts(4). Chlorophenols can be irreversibly immobilized by covalent bonding to soil organic matter (SOM). Irreversible binding increased with the addition of hydrogen peroxide and under anoxic conditions(5).
no data available
The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.
Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.
ADR/RID: UN2020 (For reference only, please check.)
IMDG: UN2020 (For reference only, please check.)
IATA: UN2020 (For reference only, please check.)
ADR/RID: CHLOROPHENOLS, SOLID (For reference only, please check.)
IMDG: CHLOROPHENOLS, SOLID (For reference only, please check.)
IATA: CHLOROPHENOLS, SOLID (For reference only, please check.)
ADR/RID: 6.1 (For reference only, please check.)
IMDG: 6.1 (For reference only, please check.)
IATA: 6.1 (For reference only, please check.)
ADR/RID: III (For reference only, please check.)
IMDG: III (For reference only, please check.)
IATA: III (For reference only, please check.)
ADR/RID: Yes
IMDG: Yes
IATA: Yes
no data available
no data available
Insufficient data are available on the effect of this substance on human health, therefore utmost care must be taken.See ICSCs 0849 and 0850.