Acute toxicity - Category 4, Oral
Skin irritation, Category 2
Serious eye damage, Category 1
Specific target organ toxicity – single exposure, Category 3
H302 Harmful if swallowed
H315 Causes skin irritation
H318 Causes serious eye damage
H335 May cause respiratory irritation
P264 Wash ... thoroughly after handling.
P270 Do not eat, drink or smoke when using this product.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/...
P261 Avoid breathing dust/fume/gas/mist/vapours/spray.
P271 Use only outdoors or in a well-ventilated area.
P301+P317 IF SWALLOWED: Get medical help.
P330 Rinse mouth.
P302+P352 IF ON SKIN: Wash with plenty of water/...
P321 Specific treatment (see ... on this label).
P332+P317 If skin irritation occurs: Get medical help.
P362+P364 Take off contaminated clothing and wash it before reuse.
P305+P354+P338 IF IN EYES: Immediately rinse with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P317 Get medical help.
P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.
P319 Get medical help if you feel unwell.
P403+P233 Store in a well-ventilated place. Keep container tightly closed.
P405 Store locked up.
P501 Dispose of contents/container to an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.
no data available
Fresh air, rest. Refer for medical attention.
Remove contaminated clothes. Rinse and then wash skin with water and soap.
Rinse with plenty of water (remove contact lenses if easily possible).
Refer for medical attention .
Dust may cause swelling of eyes and eye injury, irritation of nose and throat. Solid irritates skin on prolonged contact. (USCG, 1999)
SYMPTOMS: Symptoms of exposure to this type of compound include irritation of the nose and pharynx. It can produce redness, edema and chemical burns on skin contact. In the eyes it induces conjunctival irritation, corneal injury and iritis. Symptoms of exposure to a related compound may include respiratory system irritation, eye irritation, softening and whitening of the skin followed by the development of painful burns, headache, dizziness, rapid and difficult breathing, weakness, collapse, abdominal pain, nausea, vomiting, internal damage, digestive disturbances, nervous disorders, skin eruptions, liver and kidney damage and dermatitis. Other symptoms may include coma, painless blanching or erythema, corrosion, profuse sweating, intense thirst, diarrhea, cyanosis from methemoglobinemia, hyperactivity, stupor, decrease in blood pressure, hyperpnea, hemolysis, convulsions, pulmonary edema followed by pneumonia, jaundice, oliguria, anuria and skin sensitivity reactions. Skin contact may result in central nervous system damage, cerebral edema and muscle contractions. ACUTE/CHRONIC HAZARDS: A related compound may be absorbed through the skin. (NTP, 1992)
For advanced treatment: Consider orotracheal or nasotracheal intubation for airway control in the patient who is unconscious or in respiratory arrest. Positive-pressure ventilation techniques with a bag-valve-mask device may be beneficial. Monitor cardiac rhythm and treat arrhythmias if necessary . Start an IV with D5W TKO /SRP: To keep open, "minimal flow rate"/. Use lactated Ringer's if signs of hypovolemia are present. Watch for signs of fluid overload. Consider drug therapy for pulmonary edema . For hypotension with signs of hypovolemia, administer fluid cautiously. Consider vasopressors for hypotension with a normal fluid volume. Watch for signs of fluid overload . Administer 1% solution methylene blue if patient is symptomatic with severe hypoxia, cyanosis, and cardiac compromise not responding to oxygen. . Treat seizures with diazepam (Valium). ... Use proparacaine hydrochloride to assist eye irrigation . Phenols and related compounds/
Extinguish fire using agent suitable for type of surrounding fire. Material itself does not burn or burns with difficulty.
Excerpt from ERG Guide 153 [Substances - Toxic and/or Corrosive (Combustible)]: Combustible material: may burn but does not ignite readily. When heated, vapors may form explosive mixtures with air: indoors, outdoors and sewers explosion hazards. Those substances designated with a (P) may polymerize explosively when heated or involved in a fire. Contact with metals may evolve flammable hydrogen gas. Containers may explode when heated. Runoff may pollute waterways. Substance may be transported in a molten form. (ERG, 2016)
Flash point data for this chemical are not available; however, it is probably combustible. (NTP, 1992)
Use foam, dry powder, carbon dioxide.
Personal protection: filter respirator for organic gases and particulates adapted to the airborne concentration of the substance. Do NOT let this chemical enter the environment. Sweep spilled substance into covered containers. If appropriate, moisten first to prevent dusting. Carefully collect remainder. Then store and dispose of according to local regulations.
Personal protection: filter respirator for organic gases and particulates adapted to the airborne concentration of the substance. Do NOT let this chemical enter the environment. Sweep spilled substance into covered containers. If appropriate, moisten first to prevent dusting. Carefully collect remainder. Then store and dispose of according to local regulations.
Land Spill: Dig a pit, pond, lagoon, or holding area /SRP: If time permits, pits, ponds, lagoons, soa holes, or holding areas should be sealed with an impermeable flexible membrane liner./ to contain liquid or solid material. Cover solids with plastic sheet to prevent dissolving in rain or fire fighting water.
NO open flames. Above 62°C use a closed system and ventilation. Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.
Store in an area without drain or sewer access. Provision to contain effluent from fire extinguishing. Separated from strong oxidants and food and feedstuffs.
Component | 2,3,4-trichlorophenol | |||
---|---|---|---|---|
CAS No. | 15950-66-0 | |||
Limit value - Eight hours | Limit value - Short term | |||
ppm | mg/m3 | ppm | mg/m3 | |
Denmark | ? | 0,5 | ? | 1 |
Sweden | ? | 0,5 | ? | 1,5 (1) |
Remarks | ||||
Sweden | (1) 15 minutes average value |
no data available
Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.
Wear safety goggles or eye protection in combination with breathing protection if powder.
Protective gloves.
Use local exhaust or breathing protection.
no data available
Trichlorophenol is a solid crystals or flakes with a strong disinfectant odor. Sinks in water. (USCG, 1999)
Solid crystals or flakes
Strong disinfectant odor
75-79°C(lit.)
260.3°C at 760 mmHg
Combustible. Gives off irritating or toxic fumes (or gases) in a fire.
no data available
111.2°C
Not flammable (USCG, 1999)
no data available
no data available
no data available
less than 1 mg/mL at 68° F (NTP, 1992)
3.6
0.00763mmHg at 25°C
1.596 g/cm3
(air = 1): 6.8
no data available
Decomposes on heating and on burning. This produces toxic fumes. Reacts with oxidants, acid anhydrides and acid chlorides.
no data available
Non-combustiblePhenols, such as TRICHLOROPHENOL, do not behave as organic alcohols, as one might guess from the presence of a hydroxyl (-OH) group in their structure. Instead, they react as weak organic acids. Phenols and cresols are much weaker as acids than common carboxylic acids (phenol has pKa = 9.88). These materials are incompatible with strong reducing substances such as hydrides, nitrides, alkali metals, and sulfides. Flammable gas (H2) is often generated, and the heat of the reaction may ignite the gas. Heat is also generated by the acid-base reaction between phenols and bases. Such heating may initiate polymerization of the organic compound. Phenols are sulfonated very readily (for example, by concentrated sulfuric acid at room temperature). The reactions generate heat. Phenols are also nitrated very rapidly, even by dilute nitric acid.
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
See Notes.
See Notes.
No indication can be given about the rate at which a harmful concentration of this substance in the air is reached on evaporation at 20°C.
Terrestrial Fate: Studies on the aerobic and anaerobic degradation of phenol and selected chlorophenols were carried out using clay loam soil containing no added nutrients. The phenolic cmpd were added to flasks containing soil to give an initial concn of 100 ug/g wet wt soil. Under aerobic conditions, ... 2,4,5-trichlorophenol was ... degraded by microorganisms. Under anaerobic conditions, none of the cmpd studied were degraded by microorganisms. The cmpd appeared to stimulate microbial growth in the soil. Phenol and selected chlorophenols
no data available
no data available
no data available
The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.
Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.
ADR/RID: UN2020 (For reference only, please check.)
IMDG: UN2020 (For reference only, please check.)
IATA: UN2020 (For reference only, please check.)
ADR/RID: CHLOROPHENOLS, SOLID (For reference only, please check.)
IMDG: CHLOROPHENOLS, SOLID (For reference only, please check.)
IATA: CHLOROPHENOLS, SOLID (For reference only, please check.)
ADR/RID: 6.1 (For reference only, please check.)
IMDG: 6.1 (For reference only, please check.)
IATA: 6.1 (For reference only, please check.)
ADR/RID: III (For reference only, please check.)
IMDG: III (For reference only, please check.)
IATA: III (For reference only, please check.)
ADR/RID: No
IMDG: No
IATA: No
no data available
no data available
Insufficient data are available on the effect of this substance on human health, therefore utmost care must be taken.No data are available on this isomer but a mixture of trichlorophenols may cause irritation of the skin, eyes and respiratory tract.These substances may cause acute metabolic effects resulting in damage in several organs notably CNS.Some technical products may contain highly toxic impurities including polychlorinated dibenzo-p-dioxins and furans.Depending on the degree of exposure, periodic medical examination is suggested.