Acute toxicity - Category 3, Oral
Serious eye damage, Category 1
Skin sensitization, Category 1
Acute toxicity - Category 3, Inhalation
Germ cell mutagenicity, Category 1B
Specific target organ toxicity – repeated exposure, Category 2
Hazardous to the aquatic environment, long-term (Chronic) - Category Chronic 3
H301 Toxic if swallowed
H318 Causes serious eye damage
H317 May cause an allergic skin reaction
H331 Toxic if inhaled
H340 May cause genetic defects
H373 May cause damage to organs through prolonged or repeated exposure
H412 Harmful to aquatic life with long lasting effects
P264 Wash ... thoroughly after handling.
P270 Do not eat, drink or smoke when using this product.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/...
P261 Avoid breathing dust/fume/gas/mist/vapours/spray.
P272 Contaminated work clothing should not be allowed out of the workplace.
P271 Use only outdoors or in a well-ventilated area.
P203 Obtain, read and follow all safety instructions before use.
P260 Do not breathe dust/fume/gas/mist/vapours/spray.
P273 Avoid release to the environment.
P301+P316 IF SWALLOWED: Get emergency medical help immediately.
P321 Specific treatment (see ... on this label).
P330 Rinse mouth.
P305+P354+P338 IF IN EYES: Immediately rinse with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P317 Get medical help.
P302+P352 IF ON SKIN: Wash with plenty of water/...
P333+P317 If skin irritation or rash occurs: Get medical help.
P362+P364 Take off contaminated clothing and wash it before reuse.
P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.
P316 Get emergency medical help immediately.
P318 IF exposed or concerned, get medical advice.
P319 Get medical help if you feel unwell.
P405 Store locked up.
P403+P233 Store in a well-ventilated place. Keep container tightly closed.
P501 Dispose of contents/container to an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.
no data available
Fresh air, rest.
Remove contaminated clothes. Rinse skin with plenty of water or shower.
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.
Rinse mouth. Induce vomiting (ONLY IN CONSCIOUS PERSONS!). Refer for medical attention .
no data available
Basic treatment: Establish a patent airway. Suction if necessary. Watch for signs of respiratory insufficiency and assist ventilations if needed. Administer oxygen by nonrebreather mask at 10 to 15 L/min. Monitor for pulmonary edema and treat if necessary . Monitor for shock and treat if necessary . Anticipate seizures and treat if necessary . For eye contamination, flush eyes immediately with water. Irrigate each eye continuously with normal saline during transport . Do not use emetics. For ingestion, rinse mouth and administer 5 ml/kg up to 200 ml of water for dilution if the patient can swallow, has a strong gag reflex, and does not drool . Cover skin burns with dry sterile dressings after decontamination . Poison A and B
Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)
Flash point data for this chemical are not available; however, it is probably combustible. (NTP, 1992)
Use foam, powder, carbon dioxide.
Personal protection: particulate filter respirator adapted to the airborne concentration of the substance. Do NOT let this chemical enter the environment. Sweep spilled substance into covered sealable containers. Carefully collect remainder. Then store and dispose of according to local regulations.
Personal protection: particulate filter respirator adapted to the airborne concentration of the substance. Do NOT let this chemical enter the environment. Sweep spilled substance into covered sealable containers. Carefully collect remainder. Then store and dispose of according to local regulations.
Collect and arrange disposal. Keep the chemical in suitable and closed containers for disposal. Remove all sources of ignition. Use spark-proof tools and explosion-proof equipment. Adhered or collected material should be promptly disposed of, in accordance with appropriate laws and regulations.
NO open flames. Closed system, dust explosion-proof electrical equipment and lighting. Prevent deposition of dust. Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.
Well closed.
TLV: 0.05 mg/m3, as TWA.MAK: sensitization of respiratory tract and skin (SAH)
no data available
Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.
Wear safety goggles or eye protection in combination with breathing protection.
Protective gloves. Protective clothing.
Use local exhaust or breathing protection.
no data available
Solid. Particulates.
White.
no data available
> 94 - < 95 °C. Atm. press.:> 1 010 - < 1 030 hPa. Remarks:Performed at ambient pressure.
> 240 °C. Atm. press.:Ca. 103 500 Pa. Remarks:Boiling point technicaslly not determinable.
Combustible. Gives off irritating or toxic fumes (or gases) in a fire.
no data available
64°C(lit.)
>200°C (technical grade)
no data available
> 6.5 - < 7.6.
no data available
less than 1 mg/mL at 68° F (NTP, 1992)
log Pow = Ca. -0.8. Temperature:95 °C.
< 0.007 Pa. Temperature:Ca. 20 °C.
> 1.42 - <= 1.44 g/cm3. Temperature:20 °C.
no data available
no data available
The substance may polymerize due to heating to more than 120°C for more than 12 hours, or under the influence of catalysts. Decomposes on burning. This produces toxic fumes including nitrogen oxides. The molten form reacts rapidly with primary and secondary amines, carboxylic acids and anhydrides, thiols, phenols and alcohols.
Bulk: After heating at 60 °C for 30 days in the dark, the sample purity dropped from > 99% to 93 ± 1 %. (HPLC) Solution: A solution in water decomposed 29% in 72 hours. Aqueous solutions are most stable at pH 6. When acetonitrile was substituted for water as the storage solvent, < 1% decomposition was observed through 72 hours (HPLC).
Dust explosion possible if in powder or granular form, mixed with air.Epoxides are highly reactive. They polymerize in the presence of catalysts or when heated. These polymerization reactions can be violent. Compounds in this group react with acids, bases, and oxidizing and reducing agents. They react, possibly violently with water in the presence of acid and other catalysts.
no data available
Triglycidyl isocyanurate reacts rapidly with primary and secondary amines, carboxylic acids and anhydrides, thiols, phenols, and alcohols.
Combustion products include carbon dioxide, carbon monoxide, and oxides of nitrogen.
no data available
no data available
no data available
no data available
no data available
no data available
The substance is severely irritating to the eyes. The substance may cause effects on the central nervous system, kidneys, liver, lungs and gastrointestinal tract. This may result in tissue lesions.
Repeated or prolonged contact may cause skin sensitization. May cause heritable genetic damage to human germ cells.
Evaporation at 20°C is negligible; a harmful concentration of airborne particles can, however, be reached quickly when dispersed, especially if powdered.
no data available
no data available
no data available
no data available
The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.
Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.
ADR/RID: no data available
IMDG: no data available
IATA: no data available
ADR/RID: no data available
IMDG: no data available
IATA: no data available
ADR/RID: 6.1 (For reference only, please check.)
IMDG: 6.1 (For reference only, please check.)
IATA: 6.1 (For reference only, please check.)
ADR/RID: III (For reference only, please check.)
IMDG: III (For reference only, please check.)
IATA: III (For reference only, please check.)
ADR/RID: No
IMDG: No
IATA: No
no data available
no data available
Technical grade of this substance is a mixture of alpha and beta isomers.